itsphil 's

Post Rebuild Flight Footage.

Post Rebuild Flight Footage.

First flight post rebuild went well. Drone seems to handle as it did. Moved the batteries from underneath dead centre to the rear to balance the drone after I moved camera further out to the front, this seems to have worked and has not affected the drone in any way. Having reviewed the footage I thought it wasn’t as stable as pre crash. I checked […]

Read Me

Rebuild nearly complete.

Rebuild nearly complete.

So the rebuild is nearly complete. All broken bits have been changed, modes to wiring made, about ready for some final checks and a test fly.

Read Me

New Landing Gear Arrives

New Landing Gear Arrives

New landing gear arrives, well the parts at least.  You are probably thinking “why do you need new landing gear?” I use to have lifting legs from Tarot (like pictured below), but the servos seem to be a weak point if you are landing a little to hard, I know…. “don’t land so hard”, but as I have managed to get through 3 servos so […]

Read Me

Strip down begins.

Strip down begins.

Now most parts have arrive I can start the strip down and rebuild. Damaged list so far, I’ll update as i go. Motor – wires ripped right out of motor casing. Arm – Snapped off Lift legs – servo ripped apart. Skid – Carbon rob snapped Camera Gimbal – 2x vibration bush gone Camera Gimbal – Pan motor pulled appart. GPS mast – Snapped Video […]

Read Me

Parts Arrive.

Parts Arrive.

Finally parts arrive from Tarot China so i can start to rebuild following my fly away. Some may wonder about the time gap, just life and work keeping me away from my drone.   Ordered all parts direct, adds time to the delivery but its so much cheaper and the savings mean I can buy more spares and bits for future upgrades. You have to […]

Read Me

Bits n Pieces the results….

Bits n Pieces the results….

The results of a fly away. I had turned on Return To Launch, all looked good to start with, drone gained high as it would normally but it rolled hard to the right and headed straight for the ground.  

Read Me

Storm32 Gimbal in full effect

Storm32 Gimbal in full effect

Finally after some serious playing, making a custom lead, reprogramming both the storm32 and the pix hawk i have managed to get the Pan, Tilt and Roll working using the MAVLink protocol                           Useful Links http://www.olliw.eu/storm32bgc-wiki/Getting_Started http://ardupilot.org/copter/docs/common-storm32-gimbal.html    

Read Me

Controls plus Video Monitor

Controls plus Video Monitor

Add video monitor, forward facing camera and a video switcher to the drone allowing me to now see where I’m going and what I’m recording.       

Read Me

First Yi Camera Footage

First Yi Camera Footage

Video from first flight using my Yi camera mounted on Storm32 3 Axis Brushless Gimbal. Some serious Jello can been seen on the video and you can see the props. I guess up rated gimbal vibration dampers might help the jello. Surprised i can see the props, guess the Yi Camera has a wider angle lens than I thought. I’ll have to see what it’s like […]

Read Me

Now time for the brains.

Now time for the brains.

Now time for the brains, Pixk Hawk in place, I am using the external GPS / Compass on a mast rather than the internal Pixc Hawk GPS as i figure it will get less interference and give a cleaner more stable position.      

Read Me